Progress PAG7530E-B Uživatelský manuál stáhnout pdf (Strana 27)

this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you

must fit an applicable pressure adjuster on

the gas supply pipe.

Adjustment of minimum level

(only for Belgium)

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

bypass screw position (A).

A

5. If you change:

• from natural gas G20/G25 20/25

mbar to liquid gas, fully tighten the

bypass screw in.

• from liquid gas to natural gas

G20/G25 20/25 mbar, undo the

bypass screw approximately 1/4 of a

turn (1/2 of a turn for Triple Crown

burner).

WARNING! Make sure the

flame does not go out when you

quickly turn the knob from the

maximum position to the

minimum position.

Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable and a plug.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the appliance

is in connection with an extension cable,

an adapter or a multiple connection.

Make sure that the ground connection

agrees with the standards and

regulations.

• Do not let the power cable to heat up to

a temperature higher than 90° C.

Make sure that you connect the

blue neutral cable to the terminal

with a letter "N" on it. Connect

the brown (or black) phase

cable to the terminal which has

a letter "L". Keep the phase

cable connected at all times.

Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-F T90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth wire

must be approximately 2 cm longer than

the brown (or black) phase wire.

Building In

min.

55 mm

min.

650 mm

560 mm

480 mm

min.

150 mm

30 mm

Progress 27

1 2 ... 22 23 24 25 26 27

Komentáře k této Příručce

Žádné komentáře