
2
B
1
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
7.
Pull the door trim to the front to re-
move it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence. In-
stall the smaller panel first, then the larger.
WHAT TO DO IF…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The cooking zones do not op-
erate.
Refer to the operating instructions for the built-in cooking surface.
The appliance does not heat
up.
The appliance is deactivated. Activate the appliance
The appliance does not heat
up.
The clock is not set. Set the clock. Refer to "Setting
and changing the time".
The appliance does not heat
up.
The necessary settings are not
set.
Make sure that the settings are
correct.
The appliance does not heat
up.
The automatic cut-out is activa-
ted.
Refer to „Automatic switch-off“.
The appliance does not heat
up.
The fuse is released. Make sure that the fuse is the
cause for the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows C3. You want to the start pyrolytic
cleaning but you did not close
the oven door correctly.
Fully close the door.
progress 29
Komentáře k této Příručce